Skip to the beginning of the images gallery

Zebra TC52x/TC52ax/TC57x Elec Trigger Assembly - TRG-TC5X-ELEC1-02

$370.64 $407.70

Zebra Trigger Assembly - Electrical
TRG-TC5X-ELEC1-02
Trigger / Gun Assembly for Zebra TC52x, Zebra TC52ax and Zebra TC57x Devices
When used, Trigger Handle accessory offers customers the option of using the product in a gun form factor, ideal for scan-intensive situations.
GENUINE Zebra Part.

NOTE: See Compatibility and Requirements Below

Device sold separately.

✅ In Stock

SKU

TRG-TC5X-ELEC1-02

Uses electrical trigger via contacts on back side of Zebra TC52x, Zebra TC57x and Zebra TC52ax non-Healthcare models.
Use Trigger Handle with mechanical trigger operation for other Zebra TC5X models.
Trigger Handle attaches to the mounts on the Rugged Boot (required). There are no mounting points on the terminal itself.
Provides access to rear facing camera and flash allowing camera to be used while using the trigger handle.

Requires (Sold Separately):

Rugged Boot/Exoskeleton without hand strap (SG-TC5X-EXONHS-01).

Rugged Boot/Exoskeleton with handstrap (SG-TC5X-EXO1-01) can also be used, but the hand strap will need to be removed before using with the trigger handle.

Important - Please Note!

For Zebra TC52ax units with SE55 Advanced Range Imager - These devices require instead:

Rugged Boot/Exoskeleton with Handstrap (SG-TC52AX-EXOLOL-01). Hand strap will need to be removed.

Please Contact Us prior to purchase if your unclear as to your exact requirements.

The Zebra TC5X trigger handle accessory is considered a consumable item which may need to be replaced during the life of a Zebra TC5X device. Therefore, Zebra highly recommends the purchase of a Zebra OneCare trigger handle service plan.